Introducing the next step forward in technology!

Ventex “Generation III” UL 2161 Listed Products — Technology so advanced, no other neon power supply or transformer even comes close in performance and reliability to Ventex units. With new exclusive Ventex "Triple-Shot", "Surge" and "Brownout" protection, Generation III technology does more than any other electronic neon power supply or transformer to keep your signs on and protect your investment.

• "Triple-Shot" Protection — Automatically turns on up to three times for intermittent problems to resist spurious trips.

• "Surge" Protection — Clamps primary incoming voltage spikes on outdoor CL units (up to 2500 joules energy spike) to prevent internal damage due to over-voltage and line surges.

• "Brownout" Protection — Eliminates false tripping due to dips in primary voltage.

In addition, the proven“Generation II” technological breakthroughs are still incorporated into each and every “Generation III” unit to ensure maximum performance.

• LALR (Line and Load Regulation) — Automatically maintains consistent brightness between letters. Line and Load regulation means the smallest letter “i” is as bright as the largest letter "W".

• SST (Soft Start Technology) — Combined with Ventex's "Triple-Shot" virtually eliminates nuisance tripping on start-up. Ventex neon power supplies detect the higher strike voltage and automatically compensate to reduce false tripping.

• PDS (Phase Detection System) — Compares Load vs. Capacitance Current to provide full GFI protection and eliminate most false tripping.

Greater Energy Savings — Ventex standard HPF (High Power Factor) electronic neon power supplies draw minimal input current which lowers energy consumption. Ventex units can save up to 66% of the energy used by standard electromagnetic neon transformers. Lower input current means you can put up to seventeen fully loaded VT 9030CL-120 units on a single 20A circuit. Ventex neon power supplies are comparable to LED systems in energy consumption for a fraction of the cost!

Features Built Into All Generation III Ventex Products —
• UL 2161 Listed, CUL Approved
• Self-adjusting output voltage
• Line & load regulated for consistent mA output
• "Triple-Shot" Technology
• "Brownout" protection
• LALR, SST and PDS circuitry
• High Power Factor / High Efficiency Designs
• Maximum overload shutdown protection
• Open circuit and ground fault protection
• Patented active anti-migration circuitry
• No neon bubbling
• Built-in GTO grommets to accept GTO sleeving
• Grounded mounting foot
• Conforms to standard footage charts
• Requires no special tube processing
• Units are flashable (with external controller)